Cembre

Points of View Categories Applications Catalogues

Index

Related articles

Control and automation panels

The range of Cembre products related to supply demands for control and automation panels is particularly wide

Read more

TERMINAL BLOCK MARKER LABELS
CodeMG-VYB

precut, self adhesive

Certificates

2011/65/EU 2011/65/EU

Laboratory Test

CEI EN 60950-1

i INDELIBILITY

Information technology equipment - Safety
Part 1: General requirements
§ 1.7.11 Durability

Compliance is checked by inspection and by rubbing the marking by hand for 15 s with a piece of cloth soaked with water and again for 15 s with a piece of cloth soaked with hexane.

After this test, the marking shall be legible; it shall not be possible to remove marking plates easily and they shall show no curling.

CEI EN 61010-1

i INDELIBILITY

Ed.2 equivalent to VDE 0411-1

Safety indications for electric devices for measurement, control and laboratory use
Part 1: General indications

This regulation requires that both material and the print shall withstand‚ cleaning with chemical agents commonly used in industry.

By rubbing manually by hand, without excessive pressure, for 30 seconds with a cloth soaked in the specific detergent or, if not specifi ed, Isopropyl Alcohol.

CEMBRE STANDARD

i INDELIBILITY

This test was created to simulate cleaning with chemical products commonly used on various surfaces.

By wiping with a cloth soaked in 95% Ethanol 30 times and making a visual inspection after every 10 passes.

CEI EN 60464-2

i RESISTANCE TO SOLVENT VAPOUR

Resistance to solvent vapour is verified by the condition of the test sample following exposure

The standard requires the sample to be placed in a container of the specified solvent.

The test samples must be suspended vertically with the lower edge around 150 mm above the surface of the test solvent. During the exposure, the liquid must not evaporate completely and, if necessary, must be topped up.

The temperature of the test solvent must be 23 ± 2 °C and the duration of exposure must be 168h ± 1 (seven days).

After removal from the container, each test sample must be examined to determine whether there has been any change in appearance, loss of adherence of the sub layer, exfoliation, detachment, bulging or other signs of deterioration.

The solvents used by Cembre for this test are: Acetone, Ethanol, Hexane

DIN 30643

Technical characteristics Other characteristics

Material PVC film
Silicon free yes
Min operating temperature range -30 °C
Max operating temperature range 70 °C
Min application temperature 10 °C
Max application temperature 40 °C
Geometric shape rectangular with square corners
Precut yes

Media gallery other media

TERMINAL BLOCK MARKER LABELS MG-VYB

List of products

MG-VYB

Loading...

Cembre Via Serenissima, 9 - 25135 Brescia - ITALY

© Copyright 2017 Cembre S.p.A.
Partita IVA 00541390175